How to Integrate the reev Software into a Schneider Electric Charging Station
You will learn how to integrate the reev software into a Schneider Electric charging station.
The integration can be done independently in just a few simple steps.
Supported Models
Parking Lot 3
What is required for integration?
reev Operator Set
Should already be received by the operator / CPO (CPO = Charge Point Operator) or the assigned service provider. This includes all necessary onboarding materials such as:
QR code stickers
SIM card
Activation code
Laptop
You will need a laptop to connect to the control unit of the charging infrastructure using an RJ45 data cable.
An active internet connection via Ethernet or WiFi to establish a connection with the reev backend.
Step-by-step Integration
The following chapters demonstrate the integration process step by step. If you have all the required materials mentioned above at hand, you can carry out the integration in parallel.
Getting Started
Open a browser and enter the following IP address:
192.168.123.123:81/loginLog in using the credentials provided with the charging station.
Upon successful login, you will reach the dashboard.
The connection status will show whether there is a backend connection.
Network Settings
Check that the network settings match those shown in the provided screenshot.
Backend Settings
Enter the following address under
"WebSockets JSON OCPP URL of the backend":
wss://ocpp.reev.com
System Settings
Ensure that the logging level is set to:
LOG_LEVEL_DBG
Completing the Integration
Once the entered settings have been transmitted, the dashboard will indicate that the connection status has changed to “Connected”.
