This guide outlines the integration process of the reev backend software into supported charging stations. Here an overview: https://reev.com/en/customers-partners/hardwarepartner/
Prerequisites
reev Set (includes: SIM card, QR code stickers, activation code)
Check the vendor manual for specific installation guidance and on how to configure the station
Configuration Requirements
The charging station must be on the latest firmware version.
Charging stations must be preconfigured for inter-device communication, including:
Static IP setup or DHCP
Network topology (e.g. switches, WiFi)
Step-by-Step Procedure
1. Configure Network Settings
1.1 LTE Setup (Skip if using LAN)
Insert SIM into the charging station and navigate to the "Network" section and set:
APN: emonvia
APN Username: Leave blank
APN Password: Leave blank
Note: Delete APN details if connecting via LAN.
1.2 LAN Configuration
Under Ethernet configuration:
Static: Manually enter IP and network settings.
DHCP Server: Automatically assign IP.
Important: Ensure WLAN router setting is enabled when using unmanaged switches.
2. Backend Configuration
Navigate to the "Backend" menu and configure:
Connection Type:
GSMChargePointID:
Manufacturer_SerialNumberReplace all
.with_
OCPP Mode:
OCPP-J-1.6OCPP URL (WebSocket):
wss://ocpp.reev.com
Troubleshooting
If no backend connection is established:
Verify all previous configuration steps.
Confirm:
SIM insertion
Correct APN (if using LTE)
Valid backend URL
Proper IP settings
OCPP charge point ID formatting