Skip to main content

User groups | Activation failed

This article explains why a user group cannot be activated on a charging group and how to resolve each error message.


Why can't I activate a user group on a charging group?

If you cannot activate a user group on a charging group, one of the following error messages may appear. Each section below describes the cause and how to fix it.


Error messages and solutions

Charging group offline

A charging group is offline when there is no connection between the reev backend and the controller charging station of the charging group. In most cases, the mobile connection of the SIM card in the controller charging station is not active.

Restart the charging group physically. This often re-establishes the connection. If the problem remains or occurs again, contact reev Support.

For more information and solutions for the offline state, see Charging points offline.

GPS coordinates missing

To activate the eRoaming user group on a charging group, you must first enter the GPS coordinates of that charging group in the reev Platform. Users of our EMP partners use these coordinates to find your charging group.

Enter the GPS coordinates for each charging group. For instructions, see Public charging at a glance.

Registration with the Bundesnetzagentur missing or not confirmed

Before you can activate the eRoaming user group, your charging infrastructure must be registered with the Bundesnetzagentur (BNetzA). The user group cannot be activated without a completed registration.

After a successful registration, you receive a confirmation email with a registration ID per charging point. Enter the numbers in the reev Platform. Go to Monitoring → Charging Infrastructure → Show details → Public charging settings.

For more information about the registration and the full setup of public charging, see Public charging at a glance.

EVSE ID missing

An EVSE ID is the unique identifier of a charging connector. You need it for public charging and for charging with the reev App.

The EVSE ID is printed on the QR code sticker near the charging connector. It has the format DE*ONE*EXXXX.

Enter the EVSE ID for each connector. For instructions, see Add charging stations to your reev Platform.

Ad Hoc user group already exists

Unlike other user groups, only one ad-hoc user group can be activated per charging group. Check whether an ad-hoc user group is already active on the charging group. If it is, deactivate it before you activate another one.

Charging group must be calibration-law compliant

In Germany, charging stations that offer paid public charging must be calibration-law compliant (eichrechtskonform). For this reason, user groups with automatic billing (e.g.: Ad Hoc and eRoaming) cannot be activated on charging stations that are not calibration-law compliant. For more information on calibration law, see Calibration law in e-mobility.

Calibration-law compliance is built into the components of the charging station. It cannot be enabled or retrofitted in software.

Did this answer your question?