This article describes how to perform an SBC software update on ABL controller charging stations.
Prerequisites
The following prerequisites must be met before you perform the SBC update:
Access to the web interface of the ABL controller charging station (via LAN or WLAN)
Login credentials for the "Installer" role
Downloading the SBC Software
Make sure you update the SBC software to the latest available version.
Follow these steps to download the latest SBC software version:
Go to the ABL homepage.
Navigate to "Service" -> "Software".
Under "Software Controller Charging Stations" -> "Software Update", select the appropriate software version for your ABL controller charging station.
Note: The available software versions differ depending on the model (ABL eMH2, ABL eMH3 or ABL eM4). Make sure you select the correct version for your model.
Installing the SBC Update via the Web Interface
Follow these steps to install the software update on the charging station:
Open the web interface of the ABL charging station in your browser.
Under "Role Switch", switch to the "Installer" role and log in.
Navigate to "Maintenance" -> "System".
In the "Software Update" section, select the previously downloaded file.
Start the update.
Note: The SBC update can take up to 20 minutes. The duration depends on the current software version of the SBC and the number of charge points in your charging group. Do not interrupt the update process.
Verifying the Result
After the update, verify the following points:
The charging station is online and connected to the backend.
The SBC software version is up to date.
All charge points in the charging group are functioning correctly.
Troubleshooting
Problem | Possible Cause | Solution |
Update fails | Incorrect software version selected for the model | Download the correct version for your ABL model |
Charging station does not come online after update | Network connection interrupted | Check the LAN cable or LTE connection |
Update takes longer than 20 minutes | Large charging group or outdated software version | Wait and do not interrupt the process |
Contacting ABL Support
For hardware problems, contact ABL Support: ABL Support Page
Frequently Asked Questions
What is the SBC software?
The SBC (Single Board Computer) is the central control unit in ABL controller charging stations. The SBC software manages communication with the backend and the administration of charge points.
How do I find out which SBC software version is currently installed?
You can check the installed version on the web interface of the charging station.
Do I need to perform the update on each charging station individually?
The update is performed on the controller charging station. Extender charging stations connected to the controller are typically updated automatically.
Can I continue charging during the update?
No. Charging sessions are not possible during the update process. Therefore, plan the update outside of peak usage times.