Here you can learn how to integrate the reev software into a Spelsberg charging station. The integration can be done independently in a few simple steps.
Supported models: SmartPro AC
What is required for the integration?
reev Operator Kit
This must have been received by the operator / CPO (Charge Point Operator) or the assigned service provider. It contains the necessary onboarding materials such as QR code stickers, SIM card, and activation code.Smartphone with the Spelsberg Wallbox App
An active internet connection for the wallbox via Ethernet or Wi-Fi in order to establish the connection to the reev backend.
Step-by-Step Integration
The following chapters will guide you through the integration process step by step. If you have all the required items from the previous chapter at hand, you can carry out the integration in parallel.
Spelsberg App
Log in as an electrician.
Activate the service mode and confirm the settings by selecting Apply.
Start the configuration by tapping the Configure Wallbox button.
Check the Wallbox
Scan the QR code on the Spelsberg Wallbox.
Review the Basic Parameters and click Next.
Configure the Wallbox
Open the OCPP menu.
Select the backend connection type (choose between Wi-Fi and Ethernet).
Enter the OCPP ChargePointID in the following format:
SmartPro_SerialNumber(please use the serial number of the charging station).Enter the OCPP Backend URL:
wss://ocpp.reev.com/
Apply the selected settings.
Submit the Settings
Click the Submit button.
Hold your smartphone close to the wallbox’s RFID reader to transfer the configured settings. Then click Next.
If the transfer is successful, you can close the popup and the commissioning process is complete.
Commissioning for “Home Charging”
If you are not an electrician but would still like to connect your Spelsberg charging station to the reev backend, please proceed as follows.
Add your wallbox to the app.
In the System menu, go to Settings.
Open Advanced Settings.
Complete the steps Wallbox Configuration and Submit the Settings.
